Select dimension members (Report contents)

To select members for a dimension, do one of the following:

Click the name of the dimension in the dimension list on the left-hand side of a report page.
Click the name of a dimension in a dimension tile in a table or a preview chart page.

All the possible members of the selected dimension appear in the Members tab.

If any selections have been made, an asterisk appears next to the name of the tab. This enables you to know if there are any selections without clicking the tab.
The "default member" is the member that will be selected automatically if no other selections have been made. If any other selections have been made, the default member willl not appear in the report unless it is specifically selected.

When you have finished selecting dimension members, do one of the following:

Click Show updated report. Shows the report with your new member selections.
Click Show saved report. Cancels your selections and shows the saved report.

To leave this page and return to the report list, click Show report list.

Selection methods

You can use any of the following selection methods to choose dimension members.

Note: In all cases,
Check mark = Select
X = Clear

	Select/Clear single members	Use the check boxes beside dimension members to select all the members that you want to appear in the dimension.
	Select/Clear members by level	Use the "Select/Clear level x" buttons, located at the top left of the selection area, to select all the members that are on the same level. (For example, you could select the third level of every group.) Buttons affect the level that is directly beneath them. Hovering over these buttons highlights the affected level.
	Select/Clear all members	Use the "Select/Clear all members" buttons to select or clear all the dimension members at once. Hovering over these buttons highlights the entire member selection area to indicate that all members will be selected or cleared.
	Select/Clear lowest level	Use the "Select/Clear lowest level" buttons to select all the lowest level members at once. Lowest level members are members that do not have any children. That is, they do not define groups. Lowest level members may appear at many different levels and belong to various groups, but they are always at the lowest level of whatever group they are a member of.
	Select/Clear range of members	Use the "Select/Clear range" buttons to select or clear a range of adjacent members. (The "Select/clear range" buttons only appear if there is more than one dimension member.) To select a range: Click the "Select range of members" check mark button, choose a starting member, and then choose an ending member. Both members and all the members in between them will be selected. To clear a range: Click the "Clear range of members" button, choose a member, and then choose another member. Both members and all the members in between them will be unselected. As soon as you have have finished selecting or clearing a range, the selection method reverts to Single member.
	Select/Clear group and all members below it in hierarchy	Use the "Select /Clear group and all members below it in hierarchy" buttons, located after the name of a group, to select entire groups of members. Note: Selecting the checkmark for only the top level of a group, such as an "All" member, does not also select the group members. To include all the group's members in a report, as well as the top-level or "All" member, you must select the entire group.
	Show in reverse order	Reverses the order in which selected members will appear in the report.